1. Home
    2. >
  2. Categories
    3. >
  3. Hardware
    4. >
  4. How to replace SSD in MacBook Air: step-by-step instruction

How to replace SSD in MacBook Air: step-by-step instruction

Reading time6 min.
Article created
Updated

MacBook Air is one of the most popular laptop models from Apple. It differs with its compactness, ease and productivity. However, over time, there may be a need to replace SSD (a superficial reservoir) in MacBook Air. This may be due both to the obsolescence of the current SSD and to the need to increase it for data storage.

The replacement of SSD in MacBook Air is a minor procedure that can be performed independently. In this article, we will consider a step-by-step instruction to replace SSD in MacBook Air so that you can deal with this task without problems.

Step 1: Preparation

Several preliminary steps must be taken before SSD is replaced in MacBook Air. First, make sure you have a new SSD that will replace the old one. Make sure the new SSD is compatible with your MacBook Air model.

Secondly, before SSD is replaced, a backup copy of all important data from the current disc should be made. This will help you avoid losing information in case of contingencies.

After these preliminary steps, you're ready to start replacing SSD in MacBook Air. Follow the instructions below to replace SSD without problem.

Replace SSD in MacBook Air

Step 1: Prepare to replace SSD in MacBook Air.

  • Turn off MacBook Air and disconnect all cables.
  • Put MacBook Air on a clean, flat surface.
  • If necessary, provide a backup copy of the current SSD data.

Step 2: MacBook Air.

Do the following actions to open MacBook Air:

  1. Turn and remove all the rifles from the bottom of MacBook Air.
  2. Carefully disconnect the battery, following the manufacturer's instructions.
  3. Disconnect the boxes connecting the lower lid to the maternal fee.
  4. Take off MacBook Air's lower cover.

Step 3: Replacement of old SSD with new SSD.

The next steps will help replace the old SSD with a new one:

  1. Find the location of old SSD inside MacBook Air.
  2. Strike and remove the anchorages holding the old SSD.
  3. Carefully get the old SSD out of the elephant.
  4. Put a new SSD in the slot and tie it up with reinforcements.

Step 4: MacBook Air closing.

Do the following actions to close MacBook Air:

  1. Put MacBook Air's lower lid on your seat and record her rifles.
  2. Connect the boxes connecting the lower lid to the maternal fee.
  3. Put the battery in and record it with the rifles.

Step 5: Completion of SSD replacement in MacBook Air.

  • Turn on MacBook Air and check on the new SSD.
  • Recover the data from the backup copy if necessary.

Congratulations, the replacement of SSD in MacBook Air is complete!

Step 1: Preparation of tools

Before we start replacing SSD in MacBook Air, several tools need to be developed:

  • Openings: We're gonna need a set of mini-offs or a Pentalobe P5.
  • Pinzat: You're gonna need to work closely with the little details.
  • Antistatic handcuff: It is recommended that components be used to protect against static electricity.
  • USB-flush: It's necessary to create a loading disk with the macOS operating system.
  • Ventilation record or thermopath: When SSD is replaced, it is reasonable to replace thermopaste (if necessary) to improve heat discharge.

The preparation of the right tools before SSD is replaced will help to meet the challenge effectively and without damage. Be careful and careful when you treat them.

Step 2: Discharge MacBook Air

MacBook Air should be switched off before SSD is replaced. Follow the instructions below to correctly disable your device:

  1. Close all the open applications and keep all your data.
  2. Press " Appes " on the menu of the upper panel and select " Turn " .
  3. Confirm the disengagement by deleting " Turn " into the floating window.
  4. Wait till MacBook Air's completely off.

Now your MacBook Air is completely off and ready to replace SSD.

Step 3: Get the lower MacBook Air cover.

Before we begin with the SSD replacement, the lower cover of your MacBook Air must be removed. Follow these steps to do it safely and correctly:

  1. Using a suitable screwdriver, clean up the screws that hold the lower MacBook Air.
  2. Put the screwdriver aside and put your hands on the roof.
  3. Definitely hold the lid, clean it up carefully, pull it up and down the shell.
  4. Put the bottom lid in a safe place so it doesn't hurt.

Now you can proceed with further steps to replace SSD in your MacBook Air.

Step 4: Disconnect the battery from the mother's fee.

We'll continue the SSD process on MacBook Air. In order to reach a battery that is hidden under a mother's fee, it is necessary to separate the battery from the charge.

Here's the stepping instructions:

  1. Make sure your MacBook Air is off and off the charger.
  2. Turn MacBook Air so that the back is addressed to you.
  3. Use Pentalobe's opening to pull the screws that keep the back lid on the spot.
  4. Carefully remove the back cover and put it in a safe place.
  5. Now you'll see the battery above the mother's fee.
  6. Carefully disconnect the battery shelf attached to the mother's fee. Be careful and careful not to hurt the label.

After these steps, the battery will be disconnected from the mother's fee, and you will be able to continue the SSD process on MacBook Air.

Step 5: Get out the old SSD

Now that you disconnected the battery and removed the anchorages, you can start extracting the old SSD.

1. Carefully raise the green plastic loop to free the old SSD from his divorce on your mother's fee.

2. Put SSD up to free it from the upper edge of MacBook Air.

3. Carefully pull the old SSD out of the dim on the mother's dress using a plastic stick or a pink, if necessary.

Make sure the old SSD is completely removed and only left openly on the mother's dress to set up a new SSD.

Step 6: Set a new SSD

1. Put a new SSD next to the open port MacBook Air to make sure the contact passes on SSD correspond to the disengagement.

2. Carefully put a new SSD in the dilapse, attaching a small force. Make sure that SSD contacts are fully in line with port contacts.

3. If necessary, turn MacBook Air carefully and secure the new SSD so that it can be securely secured in the port.

4. Close MacBook Air's back cover and secure its screws.

Great! Now the new SSD is successfully installed in your MacBook Air. You can reboot the computer and enjoy its improved productivity and storage capacity.

Step 7: Put the battery on your mom's fee.

The accumulator of your MacBook Air will restore the energy to the laptop. In order to complete the replacement process of the SSD collector, the battery must be properly connected to the maternal fee.

Here are several steps to be taken:

  1. Make sure the battery is fully loaded.
  2. Determine where the battery is connected to the mother's fee.
  3. Connect the battery to the appropriate dial on the mother's dress with flat lips or other instrument with small sharp ends.
  4. Make sure the dips are tightly connected.
  5. Fill the battery with the fixtures.
  6. Check that the battery is properly connected by looking at it and making sure it's securely secured.

After all these steps, you can be sure that the battery is connected correctly and your MacBook Air is ready to be used with your new SSD cop.

Step 8: Close MacBook Air

After you installed a new SSD, MacBook Air should be shut down to complete the replacement process.

Do the following actions to close MacBook Air:

  1. Take the upper body of the laptop.
  2. Carefully put the upper body on the lower end.
  3. Put the rifles back in their openings.
  4. With a screwdriver, close the screws to the end, but don't pull them too tight.
  5. It must be ensured that the rifles do not come from the shell and the shell is securely closed.

Congratulations! Now you can use your MacBook Air with the new SSD.

Question-record

Can SSD be replaced by MacBook Air?

Yes, you can replace SSD in MacBook Air, but this process requires some skills and tools. If you're not sure about your abilities, you'd better get a specialist.

What tools are needed to replace SSD in MacBook Air?

To replace SSD in MacBook Air, you're gonna need Torx T5, Phillips bayonet, and a small flat lip. The Pentalobe will also be useful if your MacBook Air has special rifles.

What are MacBook Air models compatible with SSD replacement?

The replacement of SSD is possible for most MacBook Air models since 2010. However, take into account that some more new models have SSD welded on a fee and its replacement may not be possible or extricately complex.